刘也嘉, 林亲录, 肖冬梅, 张珺, 林利忠. 大米乳酸菌发酵降镉工艺优化[J]. 农业工程学报, 2016, 32(7): 276-282. DOI: 10.11975/j.issn.1002-6819.2016.07.039
    引用本文: 刘也嘉, 林亲录, 肖冬梅, 张珺, 林利忠. 大米乳酸菌发酵降镉工艺优化[J]. 农业工程学报, 2016, 32(7): 276-282. DOI: 10.11975/j.issn.1002-6819.2016.07.039
    Liu Yejia, Lin Qinlu, Xiao Dongmei, Zhang Jun, Lin Lizhong. Process optimization for lactic acid bacteria fermentation to reduce cadmium in rice[J]. Transactions of the Chinese Society of Agricultural Engineering (Transactions of the CSAE), 2016, 32(7): 276-282. DOI: 10.11975/j.issn.1002-6819.2016.07.039
    Citation: Liu Yejia, Lin Qinlu, Xiao Dongmei, Zhang Jun, Lin Lizhong. Process optimization for lactic acid bacteria fermentation to reduce cadmium in rice[J]. Transactions of the Chinese Society of Agricultural Engineering (Transactions of the CSAE), 2016, 32(7): 276-282. DOI: 10.11975/j.issn.1002-6819.2016.07.039

    大米乳酸菌发酵降镉工艺优化

    Process optimization for lactic acid bacteria fermentation to reduce cadmium in rice

    • 摘要: 为研究乳酸发酵对大米重金属镉的脱除效果,该试验以镉超标大米为原料,采用大米发酵液进行发酵降镉,通过Plackett-Burman(PB)设计、最陡爬坡试验设计和Box-Behnken设计对发酵降镉工艺进行优化。结果表明:PB试验筛选出的对大米发酵降镉效果显著影响的因素分别为加水量、强化菌种添加量和发酵温度;根据最陡爬坡确定的各因素逼近区域进行响应面试验设计,得出最佳降镉工艺为加水量120%、强化菌种添加量0.08‰、发酵温度32℃,其他发酵条件还包括米粉发酵液添加量2%、食盐添加量0.8%、以及有效降镉时间22~26 h,就镉质量分数为0.52 mg/kg的早米,此条件下降镉率为79.24%。研究结果为乳酸发酵降镉、缓解大米镉超标问题提供参考。

       

      Abstract: Abstract: A kind of rice noodle fermentation broth from Changde provides strains to remove the heavy metal cadmium in rice. And the main microbial flora in this fermented liquid is plant lactobacillus. Plant lactobacillus can break down the rice protein to make cadmium free from combining state and then move out from rice. The bacterial cell membrane can also remove cadmium from rice by the effect of adsorption. Plackett-Burman design (PBD), Steepest ascent experiment (SAE), and Box-Behnken design (BBD) were used to optimize the process of this experiment. The results showed that, main factors which obviously affected the rates of cadmium removal in rice screened by PBD were the additive quantity of water, the amount of strengthening bacteria and the fermentation temperature. We also adopted the response surface design of experiment to find the optimum fermentation conditions by using SAE that is a high efficient screening experiment method. The scopes of 3 main factors were respectively that, the additive quantity of water was from 110%-130%, the amount of strengthening bacteria was from 0.5‰ to 0.9‰ and the fermentation temperature was from 30℃ to 34℃. The optimum fermentation conditions were obtained, which were the additive quantity of water of 120%, the amount of strengthening bacteria of 0.8‰, and the fermentation temperature of 32℃. It also included the other fermentation conditions just like the additive amount of liquid yeast of 2%, the additive amount of salt of 0.8%, and the time fermentation period of 22-26 h. Under this optimal condition, the removal rate of cadmium was 79.24%. Heavy metal cadmium in rice was determined by Graphite Furnace atomic absorption spectrometry. Finally, this method was verified on its effects on 3 different batches of cadmium rice. The research results showed that this method could be used in different batches of early rice. Full rice grain was used to ferment in this experiment. And after completion of fermentation, the rice grain was still intact, which retained the comprehensive processing suitability of rice. This method which used microbial fermentation to remove the cadmium from rice was simple and convenient. It was also suitable for the industrial large-scale processing. Although the rice material after dealing with cadmium removal through fermentation could not be used in the food processing industry, it completely reached the requirements of food processing or other industry processing. Therefore, the results of this research have great significance in improving the status quo of cadmium rice in some regions.

       

    /

    返回文章
    返回