Abstract: Abstract: Deep rotary tillage is a hot and difficult problem in the research field of tillage machinery. Scholars at home and abroad have made a lot of explorations on deep rotary tillage technology and theory. At present, deep rotary tillage is mainly realized through the following three methods: 1) plowing depth was increased by directly increasing the diameter of the knife roller; 2)Two-axis stratified rotary tillage. Two rows of knife rollers are set in front and back for the first rotary tillage of the former one, and then the latter one for further rotary tillage; 3) subsoil reverse rotary tillage, that is, deep tillage is achieved by sinking the knife shaft below the surface. These three methods can achieve the goal of deep rotation tillage, but they all have their own disadvantages. Considering the characteristics of oblique rotary tilling and reverse tilling, the principle of oblique submerged reverse rotary tillage is put forward in this paper, which can not only destroy the soil by "pull" but also reduce the heaping soil as well as make the central transmission box easy to sink subsoil, and realize low energy consumption deep tilling with short knife. The back-up amount of tilting rotary tilter directly depends on the performance of tilting rotary tilter. Oblique submerged reverse rotary tillage is put forward in this paper. It is important to study the mechanism of throwing soil to optimize the design of this machine. Oblique submerged reverse rotary tillage is a new type of rotary tillage. It is important to study the mechanism of throwing soil to optimize the design of inclined subterranean reversal rotary tiller. In this paper, a simulation model of SPH (Smoothed Particle Hydrodynamics) is established on the LS-DYNA platform. The model is used to reverse the rotary tillage in different working conditions. The simulation results show that the post-soil rate of different layers in the reverse rotation of different parameters under different parameters is obtained. The post-soil rate of different layers obtained under the same conditions and the post-casting of different layers obtained by the indoor soil trough test are obtained. The soil rate was compared and analyzed. The verification results show that the maximum simulation error is 12.50%, the minimum simulation error is 0.20%, and the average error is 3.09%. Applying the corrected simulation model, the oblique angle, the forward speed, the depth of the submerged soil and the speed of the cutter roll were taken as the four factors of the test, and three levels were taken for each factor. Afterwards, the throwing rate was measured and the tilt was set. The virtual orthogonal experiment of reversing the rotary tillage and throwing soil was conducted. The test results were analyzed by the range analysis method, the variance analysis method and the regression analysis method. The data analysis results show that the primary and secondary order of the impact rate after the impact is the subsoil depth and the oblique angle, the forward speed and the knife roll speed. The influence on the post-lost rate is not significant, and the mathematical relationship model of the subsoil depth, the oblique angle and the post-lost rate is obtained. According to the results of virtual experiment, the physical prototype of the inclined submersible soil reverse rotation tillage machine was optimized and the field experiment was carried out. The field test results showed that the reverse rotation of the inclined subterranean soil successfully solved the problem of the rotary tiller bracket and the central transmission box. And with the R175 standard rotary cultivator, the tilling depth of 20 cm was achieved, and deep tilling using short knife was realized in this paper.